Excellent strength with beautiful all-ceramic esthetics
Biocompatible
More than 10 years of clinical documentation
More than 5,000,000 produced units
NobelProcera Zirconia Indications :
Any position of the mouth - including the posterior
Tooth - and implant - supported restorations
NobelProcera Crown Zirconia, 0.4 mm., is indicated for use in the esthetic region, premolar to premolar
Available in four shades: white, light, medium and intense
NobelProcera Alumina Indications :
Any position of the mouth - including the posterior
Tooth - and implant - supported restorations
NobelProcera Crown Alumina, 0.4 mm., is indicated for use in the esthetic region, premolar to premolar
NobelProcera Titanium Indications :
Any position of the mouth - including the posterior
Tooth - and implant - supported restorations
Minimum thickness 0.4 mm.
NobelProcera Crown Alumina, 0.4 mm., is indicated for use in the esthetic region, premolar to premolar
1. Preparation
Eliminate sharp edges, undercuts, and grooves.
Provide sufficient reduction (1.2 mm to 1.5 mm).
Provide adequate space for the coping and dental ceramic porcelain.
Avoid sharp angle on the occlusal surface.
Avoid creating a deep fossa/cavity.
Provide sufficient (1.5 mm to 2 mm) occlusal/incisal reduction.
Provide preparations that are excessively tapered or too close to parallel.
The ideal total occlusal convergence is 6-10 degree
2. Impression
Make an ordinary crown and bridge impression using your preferred impression material and method.
Send the impression to the laboratory.
3. Laboratory procedures
A model is made from the impression and scanned for producing a NobelProcera Crown. After production, the crown is veneered with dental ceramics.
4. Cementation
Gently seat restoration on the tooth and check both the occlusion and the interproximal contacts.
The restoration should be in light occlusion. Excursive contact should be minimal.
Note: Do not use temporary cement due to an increased risk of fracturing all-ceramic crowns.